Sherline 4-Jaw Chuck Hold-Down Set

• Sherline 4-Jaw Chuck Hold-Down Set
• Consists of two clamps complete with screws and T-nuts
• Provides a little more versatility than the chuck
• Can clamp the 4-jaw chuck to milling table or lathe cross slide
• Clamps fit in a groove machined around the circumference of the 4-jaw chuck

The Sherline 4-Jaw Chuck Hold-Down Set consists of two clamps complete with screws and T-nuts, and can be used to clamp the 4-jaw chuck to the milling table or lathe cross slide. The set provides a little more versatility than the chuck to T-slot adapter in that the chuck can be located almost anywhere on the table, and the part can be properly aligned with the axis of the machine.

The clamps fit in a groove machined around the circumference of the 4-jaw chuck. They are the same as those furnished with the Sherline milling vise and rotary table, so they are not needed if you already own either of these accessories.

NOTE: To keep the surface of your table from being marred, we recommend you take a file and slightly soften or deburr all the edges of the angle clamps which contact the table.